So the reason the part # D15660 is the most expensive is because it comes with everything needed to install as a engine oil cooler kit since it has multiple fittings as well as the sandwich adapter. This is basically the complete kit.
Next up is the # D15960 which setup to be a transmission cooler and comes with the fittings needed for this application which is considerably less than as an engine oil cooler.
Finally the # D15860 comes with minimal fittings and adapters and would require... view full answer...
The Derale oil cooler # D15405 comes with 10 feet of 1/2 inch hose. You could add another 10 feet using # D15700. Then you would just need a 1/2 inch line to 1/2 inch line hose barb fitting from an auto parts store and some additional hose clamps # D13008.
For transmission cooler # D13503 there are no special fittings required for installation. But if the included Insta-dapt fitting does not fit your external transmission cooler and the stock lines are metal you would need to cut and flare... view full answer...
There is not a vehicle-specific mounting bracket for the Derale Oil Filter Relocation Kit - 3/4-16 Engine Filter Threads # D15715.
This uses a Ports-Up Filter Mount that accepts 3/4-16 threads for oil filters like the one you mentioned. view full answer...
My contact at Edge Products suggested a different tuner for your 2007 Ford F-150 Triton 4.6L V8, their Evolution CS2 Performance Tuner # EP85350. This will allow you to read engine oil and transmission fluid temps and RPMs without adding any other parts.
The Edge Evolution Programmer for Ford Triton 4.6L V8s # EP15051 does not include temperature probes for transmission fluid or engine oil but it does allow reading engine RPMs through its connection at the OBD-II port. On your truck oil... view full answer...
Typically instructions are not included with the Derale Transmission Pan Coolers. I have contacted Derale requesting this information as well but my contact did explain that they do not have any additional instructions that I can send to you.
My contact at Derale did explain that the tubes in the pan area of this cooler are designed to be at the same height and position of a standard OEM pan cooler. Please be aware that if you do currently have a deep pan cooler it is possible that your... view full answer...